|
Cool
Tube
Howe
Aluminum Oil Cooler Tubes replace braided oil line to transfer
the oil heat into the surrounding air.
The fin design creates over 18-1/2” of exposed
circumference to increase the surface area 5 times over straight
tubing.
Aluminum has excellent thermal transfer properties, while
braided line is actually a heat insulator.
The outside diameter of the fins form a 1-3/4” diameter
allowing the tube to be bent in a standard tubing bender.
The inside diameter is sized for ¾” Pipe thread for
easy threading.
Use Aeroquip type fittings to adapt to #10, #12 or #16
oil lines.
Sold in five different pre-threaded and chamfered lengths
or in bulk up to 9’.
E2000........................................Per
Foot (Specify)
E20025......................................2-1/2"
Pre-Threaded
E2003........................................3'
Pre-Threaded
E2004........................................4'
Pre-Threaded
E2005.......................................
5' Pre-Threaded
E2006........................................6'
Pre-Threaded
E2100........................................Thread
and Chamfer Custom |
|
Inline
TRANSMISSION FLUID Cooler
3/8 NPT.
Fittings
1/4" bolt
T slot makes It easy to mount, 13"and 18" long
Before you call
and ask how much will this cool ?
Where are you
going to put it?
If
you run it right next to the exhaust pipe, it will probably
add heat to your oil!
Mount this where it can get clean air over and around it and
they have been proven to cool
very efficiently.
Can
be ordered in special lengths, and AN. fitting as well as NPT.
|
